The Armadex OmniX explosion proof antenna enables full Wi-Fi coverage in hazardous areas. Designed for use in ATEX Zone 2 (gas) and Zone 22 (dust). Combined with a special HF-barrier it can even be placed in Zones 0 and 20. For safe and reliable coverage in classified hazardous locations.
Available from stock
Key benefits of the explosion safe Omnix Wi-Fi antenna:
- Zones 2 and 22 certified
- Signal penetrates concrete and steel.
- Robust design; suitable for inside and outside purposes.
- Impact tested
- Non-arcing design, also allows connection to standard Wi-Fi access points*.
*A coaxial cable with a maximum length of 25 metres is available to connect a non-ATEX Wi-Fi Access point to the ATEX-antenna placed in the ATEX zone. For longer distances or a lossless coverage we advise to use an explosion proof ATEX Wi-Fi access point. 2,4GHz or 5GHz available
For minimal loss and optimal coverage choose the same frequency antenna as your Wi-Fi access point. Supplied with:
- ATEX marking
- Declaration of conformity category 3G/D
- Installation instruction for hazardous areas
- User Manual
- Stainless steel mounting bracket
- N-plug suitable for use up to 6 GHz
Specifications: Wifi Antenna, ATEX Certified
General Technical Specifications
|Power Supply||PoE, 12/24 V DC|
|Frequency||Dual band, 2400-2500 / 5150-5850 MHz|
|Wire line||Cat6/FTP via RJ45 or fibre optics|
|Antennas||2 or 3 pre-assembled antennas|
|Optional||Wall or ceiling mount stainless steel brackets|
Explosion Safety Specifications (ATEX)
|EU Directive||2014/34/EU (ATEX 114)|
|ATEX marking gas||II 3G Ex nA IIC Gc|
|ATEX marking dust||II 3D Ex tc IIIC T135°C Dc|
|Applied Standards||EN 60079-0; Explosive atmospheres - Part 0: Equipment - General requirements
EN 60079-15; Explosive atmospheres - Part 15 : Equipment protection by type of protection "n"
EN 60079-31; Explosive atmospheres - Part 31: Equipment dust ignition protection by enclosure "t"